Remove and discard the grommets from the roof 21. Unplug the two vehicle connectors, and remove the rear bumper. Gently left the front of the trim to release the four rear clips.Remove two bolts, six self-tapping screws and six clips from the rear bumper.Start with the left clip and work towards the right clip. Using a KTC trim tool, carefully pry up the front of the trim to release the three front clips.Remove the left rear seat belt upper anchor bol m (22 to 25 lbs) TABS REAR TRIM PANEL COVER CLIP 6 CLIPS 2 CLIPS LEFT REAR LOWER ANCHOR BOLT COVER CLIPS LEFT REAR 4212381T SEAT BELT 4715611K LOWER LEFT REAR ANCHOR PILLAR BOLT LOWER TRIM 12.Seat belt anchor bolt torque: 2 RETAINING 30 to 35 N.remove the left rear seat belt lower anchor bolt. Remove the left rear lower anchor bolt cover, and two retaining tabs). Remove the rear trim panel cover (eight clips and 14. LEFT REAR SEAT CUSHION RIGHT REAR SEAT CUSHION RIGHT REAR 8 SEAT SEAT UNDER ANCHOR COVER REAR SEAT BOLTS BELT ANCHOR 4212362T BOLT LEFT REAR SEAT UNDER 4212342T 9 CLIPSġ1. Remove the left rear seat under cover (five clips).Remove the right rear seat under cover (four.Remove the rear seat belt anchor bolt and eight under covers seat anchor bolts. Lift up the rear seats, and remove the rear seat 9. Seat belt anchor bolt torque: FUEL FILL DOOR RELEASE HANDLE 30 to 35 N.Remove the left B-pillar lower trim panel by pulling out toward you as shown. ![]() bolt cover and remove the lower anchor bolt. Remove the left seat belt lower anchor retaining tabs). Pull away the weatherstrip from the B-pillar lower the left front door sill trim (three clips and three trim panel. ![]() Remove the fuel fill door release handle. AII 36587 REAR CAMERA INSTALLATION ATTACHMENT 2006-2008 RIDGELINE Issue Date (EX-L WITH NAVI) INSTRUCTIONS MAY 2007 PARTS LIST Template Attachment Kit P/N: 08B21-SJC-102 Rear camera trim 19 Wire ties Rear camera bracket 10 Small wire ties 6 Wire ties with clip Rear camera subbracket 6-Pin connector Harness clamp bracket A Grommet Harness clamp bracket B 2 Clear adhesive tapes Rear camera subharness 3 Blind nuts © 2007 American HondĢ EPT sealers TOOLS AND SUPPLIES REQUIRED Phillips screwdriver Flat-tip screwdriver 10 mm Combination wrench Ratchet 4 Cushion tapes 10, 12 mm and 14 mm Socket Torque wrench File Isopropyl alcohol Shop towel 2 Socket bolts, 4 x 10 mm Tape measure Drill 3 mm, 8 mm, and 10 mm Drill bits Utility knife 3 Washer screws, 4 x 12 mm T40, and T50 Torx bit KTC trim tool Scissors Tape 2 Washer screws, 4 x 6 mm Electrical tape Wire 3 mm Hex wrench 7 Clips Illustration of the Rear Cģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |